3D printed using ABS this rugged case is the perfect companion for our resin knives! Strong enough to get tossed around in a play bag, this case can take a beating!

Inside has a soft, flexible TPU insert that keeps your knife from rattling around. The insert is designed in a way that the knifes hook around the bottom of the insert, locking it in place. The blade relief has a special channel at the bottom so the blades edge is suspended, not in contact with any material, extending the life of the sharp edge!

Using ABS as the base material this allows you to not have to worry about where you store them! While using PLA a case could deform even inside with direct sunlight! Even PETG can have temperature issues on the higher end! Since I use ABS, you can leave this case with your knife protected in a hot car during summer… In the south… with absolutely NO change in the cases structure!

You can mix and match the case color and the inner TPU insert. You can also remove the insert and use the case to store anything that can fit!

The exterior of the case has a holographic design that is embedded in the plastic and will not “wear off”. The top of the TPU insert will also have a holographic pattern. There are several patterns that I cycle through and is too much to add specific options for this. But the case AND the insert will have the same holographic pattern. The inner color of my logo may be a random but contrasting color as well. Custom orders are available for an extra charge for those who must have it just a certain way.